NO REAM INSTALLATION
for KING PIN STEERING KNUCKLE REPAIRS
REMOVAL
•
Use established procedures for teardown.
STEERING KNUCKLE AND AXLE
PREPARATION
•
Clean spindle and axle eyes and wipe dry.
•
Remove any burrs from spindle bores and axle eyes
using brake hone or similar device.
INSTALLING BUSHING LIP SEALS
•
Handle with care, lip seals are easily damaged.
•
Using a bushing driver or similar device, drive the
seals into the bore leaving the seal
flush with the axle side of each
spindle bore.
•
Be sure to position the seal so the
lip is pointing towards the axle eye.
(see figure #1)
SPECIAL INSTRUCTIONS FOR
INSTALLING PRESIZED BRONZE
BUSHINGS
• Using the Kaiser Plus bushing driver specifically
designed for your kit, drive both bushings into bores.
CHECK BEFORE ASSEMBLY
•
Wipe bushings clean.
•
Using king pin check for fit, first insert pin into each
bushing individually then insert pin into both bushings,
king pin should slide through both bushings
simultaneously.
•
If pin fits through bushings individually but not
simultaneously the spindle has spread and may need
replacement.
BEARING INSTALLATION
•
Prepack bearings with grease.
•
For proper bearing orientation please refer to figure #1.
•
Place needed shims under upper spindle bore.
•
Position king pin through upper spindle bore and
through needed shims, be sure TOP of pin is parallel to
axle for proper lock flat alignment.
•
Place spindle, shims and pin onto axle, allow pin to
drop into axle bore about 2".
•
Tap bearing into place, a properly fit bearing will require
a slight tap fit without damaging the bearing case.
•
If bearing is too tight or too loose, adjust the number of
shims being used.
COMPLETE PIN INSTALLATION
•
Once the bearing fit is correct, allow pin to slip into
lower bushing.
•
Position lock pin flats on pin so they line up with lock
holes.
•
Pound lock pins into place, lock pins with threads
apply 25-30 ft. lbs of torque.
END PLATE OR END PLUG
INSTALLATION
•
Install end plates or end plugs, using the proper seal
under plates.
•
Install grease fitting into end plate or end plug.
GREASING
•
Apply grease until it can be seen between axle and
spindle.
CHECK INSTALLATION
•
Once greased the spindle should turn easily from side
to side.
•
There should be very little up and down movement.
•
If unit seems loose or too tight we recommend calling
our tech line for assistance.
01 577 0038 OCT-2010
GETTING HELP
USE THE STEMCO Kaiser TECHNICAL SERVICE LINE
888-854-6474
WARNING: STRIKING STEEL PARTS WITH HAMMERS CAN RESULT IN CHIP PROJECTILES, ALWAYS WEAR SAFETY GLASSES TO PROTECT YOURSELF AGAINST
INJURY. STEMCO Kaiser IS NOT RESPONSIBLE FOR ANY INJURY THAT MAY OCCUR DURING THIS PROCESS.
4641 Industrial Drive, Millington, MI 48746 • 888-854-6474 • Fax: 989-871-4640 www.stemcokaiser.com
Cross section
of bushing lip seal.
Seal is placed on top of
thrust bearing.
figure #1
(42 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels